If extension cords are used, make sure that the core diameter is sufficient for the required
power consumption of the device. All warnings concerning the power cords are also valid
for possible extension cords.
Always disconnect from the mains, when the device is not in use or before cleaning it.
Only handle the power-cord by the plug. Never pull out the plug by tugging the power-cord.
Otherwise, the cable or plug can be damaged leading to mortal electrical shock.
If the power plug or the power switch is not accessible, the device must be disconnected
via the mains.
If the power plug or the device is dusty, the device must be taken out of operation, discon-
nected and then be cleaned with a dry cloth.
Dust can reduce the insulation which may lead to mortal electrical shock.
More severe dirt in and at the device should only be removed by a specialist.
There must never enter any liquid into power outlets, extension cords or any holes in the
housing of the device. If you suppose that also a minimal amount of liquid may have ente-
red the device, it must immediately be disconnected. This is also valid, if the device was
exposed to high humidity.
Also if the device is still running, the device must be checked by a specialist if the liquid
has reduced any insulation. Reduced insulation can cause mortal electrical shock.
There must never be any objects entering into the device. This is especially valid for metal
parts. If any metal parts like staples or coarse metal chips enter into the device, the device
must be taken out of operation and disconnected immediately. Malfunction or short-circuits
caused by metal parts may cause mortal injuries.
OPERATING DETERMINATIONS
This device is a lighting effect for creating decorative effects This product is allowed to be
operated with an alternating voltage of 100 - 240 V, 50/60 Hz~ and was designed for in-
door use only.
This device is designed for professional use, e.g. on stages, in discotheques, theatres etc.
Lighting effects are not designed for permanent operation. Consistent operation breaks will
ensure that the device will serve you for a long time without defects.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to
extreme heat, moisture or dust.
There should not be any cables lying around. You endanger your own and the safety of
others!
This device must never be operated or stockpiled in sourroundings where splash water,
rain, moisture or fog may harm the device. Moisture or very high humidity can reduce the
insulation and lead to mortal electrical shocks.
When using smoke machines, make sure that the device is never exposed to the direct
smoke jet and is installed in a distance of 0.5 meters between smoke machine and device.
Atomic4Dj Par64 Led Slim RGB – www.Atomic4Dj.com
