AtomoSynth “Mochika X4” Analog synth step sequencer.
Quick start guide.
Basic Operation.
Synthesizer Section:
1. Connect the included power supply to “12V DC ” input located in the rear panel and
connect power supply to mains.
2. Connect the “AUDIO OUT” located in the rear panel of the unit to a mixer or amplifier. Use
unbalanced ¼" connector (mono plug). Before doing so, lower the volume of your amp or
mixer. Note: the Perceptron output is not designed to be used with headphones, connect it
always to an amp or mixer.
3. Turn the unit on using the “On/off” switcher in the rear panel.
4. Set the “OSC” knob midway (center position), set the “SUB” and “Noise” knobs all the way
left (min position).
5. Set the “Wave” switcher to the upper position (saw-tooth wave).
6. Set the “Tune” knob midway (center position).
7. Set the “Filter” switch to the “LP” Low pass position, and set the “CUTOFF” knob all the way
right (max position).
8. Set the “Peak”, “OSC_M” and “Fltr_M” knobs all the way left (min position).
9. Set the “A” knob all the way left, And set the “D” “S” “R” knobs midway (center position).
10. Set the “VOLUME” knob midway (center position).
Sequencer section:
11. Push the
“STEPS”
knob/button once, the display will show “3. Step On/Off”.
12. Push the
“1-8”
knob/button, the steps 1 to 8 will be selected.
13. Turn the step knobs to the right to activate the desired step (1 to 8), the corresponding step LED
will light. To deactivate a step, turn the corresponding knob to the left, the LED will go dark.
14. Push the
“9-16”
knob/button, the steps 9 to 16 will be selected.
15. Turn the step knobs to the right to activate the desired step (9 to 16), the corresponding step
LED will light. To deactivate a step turn the corresponding knob to the left, the LED will go
dark.
16. Push the “Play/Stop” knob/button, the MochikaX4 will produce a sequence of basic pure tones.
Summary of Contents for Mochika X4
Page 1: ......
