ATOS Worldline
-
Technologies & Products
Page:
19/55
DEP/T6 Owner's Manual
(
04.01
)
Classification:
Public
If no user accounts have been registered, the system passes to
auto-identification
,
allowing the operation to be carried out without a specific user name and PIN-code.
The following information screen appears:
Identification
-- Auto Identification ---
Ok
2.4.7.
Storing settings
Any change to the settings of the DEP
/
T6, in order to be persistent, must be saved in
the flash memory of the system.
Therefore, when you leave the
System Management
, you obtain a commands menu
with three options:
System Management
1 Save and Reboot
2 Exit without Saving
3 Cancel Changes
Ok
For the settings to be saved and to take effect, select
Save and Reboot
.
If you select
Exit without saving
, the system restarts and the settings are lost. The
settings as they were last saved in the flash memory are used.
If you select
Cancel Changes
, you exit the
System Management
and the changes are
discarded.
2.4.8.
Changing the LCD set-up
2.4.8.1.Setting the display contrast
To change the contrast of the DEP
/
T6 display, proceed as follows:
1.
Open the Hardware Setting menu.
The path to follow is:
System Management
> (
Identification
)
System
Configuration
>
Hardware Setting
.
2.
Select the function
LCD Setup.
The
LCD Setup
menu screen appears.
LCD Setup
1 Contrast
2 Backlight Power Saving
3 Backlight Pwr Sav Time
Ok
