ATOS Worldline
-
Technologies & Products
Page:
24/55
DEP/T6 Owner's Manual
(
04.01
)
Classification:
Public
6.
Put the nut back in place and fix it carefully, making sure not to overtighten it,
7.
Connect the opposite end of the grounding wire to the appropriate grounding
point at your site to ensure an adequate chassis ground.
Figure 5 –
The DEP/T6 grounding connection bolt
3.3.
C
ONNECTING
I/O
CABLES
3.3.1.
Choosing an Ethernet port
The DEP
/
T6 has two Ethernet ports: Ethernet 1 and Ethernet 2. The latter is accessible
either from the front or from the rear.
The Ethernet ports can be used to connect the DEP
/
T6 to LAN or to establish a
connection to a PC, which can be used, for instance, to manage the DEP
/
T6 using the
NMS (Network Management System). The cables used in the former case are straight-
through 10/100 Ethernet cables, equipped with RJ-45 connectors. In the latter case, a
cross cable is to be used.
The Et h ernet cables are n ot av ail abl e from Atos Worl dlin e. Yo u
can o bt ain th em fro m a hardware sto re.
Not e:
For details on switching between the front and the rear Ethernet port, refer to the
section
Selecting an Ethernet jack
on page 28.
3.3.2.
Making a serial connection
The DEP
/
T6 has an RS-232 jack at the rear side to establish a serial connection to a
host. Refer to the picture in the section
Hardware overview
on page 10 for the
location of the RS-232 jack.
