APD series bench scale
APD_01_11.05_EN_U
14
9. TOTALISATION
Inside the
F.ModE >> totAL
step of the setup environment it is possible to set the parameters for the function of
totalisation:
tot.Mod:
TYPE OF TOTALIZATION
It is possible to select the type of totalisation: manual (MAnuAL) or automatic (Auto).
n.WEiGh:
NUMBER OF WEIGHS
If one sets this parameter as “yES”, for each operation of totalisation the number of weighs and the total weight are
displayed. If the total weight has more than 6 digits, its visualisation takes place in two stages.
If one sets the parameter as “no”, for each operation of totalisation only the "-tot-" message is displayed.
WAit.St:
WAIT STABILITY
Once one has set the wait stability time with a value different from 0, each operation of totalisation will be executed only
if the weight is in stability. When the weight is not stable and
M+
key is pressed, the unstable weight is displayed blinking
and one is not allowed to press any key; the totalisation will remain pending. If the wait stability time is expired and the
weight is not stable, the present accumulation will be aborted with the display of the “unStAb” message and error beeping.
If one sets this parameter with the value 255, the waiting stability time is infinite on each accumulation.
Once one has set the wait stability time at 0, if one press the
M+
key and the weight is not in stability, the operation of
totalisation is instantly aborted with the display of the “unStAb” message and error beeping.
NOTE:
This parameter takes effect only if the manual totalisation has been set.
MAx.tot:
NUMBER OF CONSECUTIVE TOTALISATIONS AFTER WHICH THE TOTAL IS AUTOMATICALLY CLEARED
After having carried out the number of totalisations set in this step, the accumulated total is shown on the display and
cleared; one can set a value between 0 and 255.
NOTE
: the value 0 disables the function.
9.1 OPERATIONS OF TOTALISATION
This scale allows to totalize the weight in load and unload.
Totalisation in load:
If the manual totalisation has been set, in order to carry out the totalisation it is necessary to load the weight on the scale
and press the
M+
key; then the weight is accumulated in the total.
If the automatic totalisation has been set, there is the automatic acquisition of the stable weight loaded on the scale and
then the accumulation of the weight in the total.
To totalize, the net weight must be:
- at least 1 division with not approved instrument and manual totalisation;
- at least 10 divisions with not approved instrument and automatic totalisation;
- at least 20 divisions with approved instrument.
Totalisation in unload:
If a tare is active, one can totalize also negative values of weight: after having executed the tare, by removing part of the
weight from the scale, the negative value of the unloaded weight is displayed and it is possible to totalize this value. The
totalisation is executed by pressing the
M+
key if the manual totalisation has been set or automatically when the weight is
stable if the automatic totalisation has been selected.
To totalize, the negative net weight must be:
- at least 1 division with not approved instrument and manual totalisation;
- at least 10 divisions with not approved instrument and automatic totalisation;
- at least 1 division with approved instrument and manual totalisation;
- at least 20 divisions with approved instrument and automatic totalisation.
Note:
to totalize the negative net weight, with not approved instrument the gross weight must be greater than or equal to
zero; with approved instrument the gross weight must be at least 20 divisions.
