9
June 2004
Seiko PS
A-66-ST
Servicing the printer
Should the printer require service outside of the
game, the sliding module which includes the major-
ity of electronics may be easily removed and replaced.
Removing the Inner Module
The sliding module of the PSA-66-ST may be re-
moved from its stationary module by following the
simple steps given below. To re-install the sliding
module, repeat the steps in reverse order.
1.
Turn off the machine power.
2. Slide the unit open until it locks in the open po-
sition.
3. Release the ribbon cable by spreading the finger
latches at the rear of the unit.
4. Push inward on the locking bar at the front of
the unit.
5. Slide the drawer module completely out of the
stationary module.
Caution:
The printer is
not
hot-connect-
able and any attempt to do so
can permanently damage the
printer!
H
ANDLING