Managing Your LAN Stations
Adjusting Network Settings for a LAN Station
34
4.7 Adjusting Network Settings for a LAN Station
For your LAN station to be managed by a host server and ready for use, an IP address assigned to the station is
required. Normally, your Atrust m320 will perform network environment detection and choose an appropriate
IP address automatically. In case that you need to adjust the network configuration for your m320, refer to the
table below as guidelines on manual adjustment. Depending on different physical connections (see “2.2 Getting
Connected” on page 13), you need to select different methods to assign the IP address.
Two Methods for Assigning an IP Address to a LAN Station
Physical Connection
Method for LAN station
Description
IP Assignment Method
Method 1
connect m320 to your local network through
the same Gigabit switch as the host server
automatically assign an IP address by
the DHCP server over your local network
Method 2
connect m320 to your local network
indirectly through the host server
manually assign an IP address
NOTE
•
Only the network settings of a free LAN station can be adjusted.
Assigning an IP address automatically by the DHCP server
To assign an IP address automatically by the DHCP server for a LAN station, please do the following:
NOTE
•
Ensure that your LAN station uses the method 1. See the description and related
section referred to at the beginning of this section.
1. On
LAN Stations
tab, click
Scan
sub-tab, and then click to select the desired free LAN station.
2. Click
Change network settings
. The Change Network Settings window appears.
3. Click to check
Use DHCP
, and then click
Submit
to apply.
Summary of Contents for m320
