Atrust P2T USB, User Manual

iii

Safety and Regulatory Information

Regulatory Statement

Federal Communications Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio communications.  However, 

there is no guarantee that interference will not occur in a particular installation.  If this equipment does cause 

harmful interference to radio or television reception, which can be determined by turning the equipment off and 

on, the user is encouraged to try to correct the interference by one of the following measures:

• 

Reorient or relocate the receiving antenna.

• 

Increase the separation between the equipment and receiver.

• 

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• 

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

 Any changes or modifications not expressly approved by the party responsible for compliance could 

void the user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is 

subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must 

accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This 

equipment should be installed and operated with minimum distance 20 cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

WEEE (Waste Electrical and Electronic Equipment) Directive

In the European Union, this symbol indicates that this product should not be disposed of with 

household waste. It should be deposited at an appropriate facility to enable recovery and recycling. For 

proper disposal, please contact your local recycling or hazardous waste center.

RoHS 2 (Restriction of the use of Hazardous Substances) Directive

This product of Atrust Computer Corp. fulfils the requirements of the EU directive 2011/65/EU on the 

R

estriction of 

the use 

o

f certain 

H

azardous 

S

ubstances in electrical and electronic equipment (RoHS 2). The CE marking is applied 

on the product accordingly.

REACH (Registration, Evaluation, Authorisation and restriction of Chemicals) Regulation

REACH  (EC 1907/2006) aims to improve the protection of human health and the environment through the better 

and earlier identification of the intrinsic properties of chemical substances. This is done by the four processes of 

REACH, namely the registration, evaluation, authorisation and restriction of chemicals. REACH also aims to enhance 

innovation and competitiveness of the EU chemicals industry. Atrust Computer Corp. and our suppliers have taken 

the necessary action to meet the requirements of REACH.