ATS Co-Pilot, Installation Manual

Locate the 

Red

 wire coming from the vehicle’s PCM Pin #

71.  

Tap this wire with the 

red

Co-Pilot wire by soldering.  Shield the tap from the elements. 

Black Wire- Ground (GND) – PIN #9 

Locate the 

Black

 wire coming from the vehicle’s PCM Pin #

51

.  Tap this wire with the 

black

Co-Pilot wire by soldering.  Shield the tap from the elements. 

Yellow Wire– PCM - PIN #10 and Blue Wire– TCC - PIN #11 

Locate the vehicle’s Torque Converter Clutch (TCC) wire coming from the vehicle’s PCM to the 

transmission.  This 

Purple w/ Yellow

 stripe wire can be found at the PCM at pin #

28

.  Cut this 

wire and solder, or attach a butt connector to the wire leading back to the transmission and attach 

a butt connector to the wire heading to the vehicles computer (PCM).  Reference the supplied 

wiring schematic before cutting wire. 

Connect the 

Yellow

 wire coming from the 

Co-Pilot 

to the wire that goes to the PCM. Connect 

the 

Blue

 wire coming from the 

Co-Pilot 

to the wire that goes to the transmission.  

Protect the connections from the elements. 

Green Wire- Vehicle Speed Sensor (VSS) – PIN #17 

Locate the VSS (Vehicle Speed Sensor) wire.  This 

Gray w/ Black

 stripe wire can be found at 

the PCM at pin #

58

 Run the green wire from the Co-Pilot module to the VSS wire and cut off 

any excess, but leave some slack.  Solder the Green Co-Pilot wire to the VSS wire and protect 

from elements, this is the most common install problem with wiring