3.2 INSTALLATION SITE
While preparing a proper site for the installation of the dryer, please take into account
the following requirements
- The machine must be protected from atmospheric agents and not directly exposed to
sun light.
- The seating base must be flat and capable to hold the weight of the machine.
- A clean, dry and without internal air recirculation (we suggest to blow the warm air
outside the installation site).
- Make sure to leave sufficient clearance around the dryer in order to allow an adequate
cooling of the machine and maintenance/control operations.
The incoming air must be free from smoke or flammable vapours which could lead to
explosion or fire risks.
3.3 INSTALLATION LAYOUT
Before attempting any installation operation, make sure that:
- no part of the system is under pressure
- no part of the system is electrically powered
- piping connections are properly sized and located in order to avoid any external force
on the dryer
- dryer is firmly secured to the ground
- a filter with a minimum filtration rate of 0.01 mg/m3 has been installed before the dryer
Flexible pipes are recommended to reduce vibration problems.
WARNING!
Incorrect installation may void warranty!
Summary of Contents for HGL 120
