4. START UP
4.1 BEFORE START UP
Before starting the machine, make sure that all operating parameters correspond to the
nominal data (operating parameters in the list attached).
The dryer is supplied already tested and present for normal operation, and it does not
require any calibration. Nevertheless, it is necessary to check the operating
performances during the first working hours.
4.2 START UP
After all piping and electrical connections have been made, proceed as
follows:
SLOWLY pressurize the dryer up to reach full operating pressure.
Energize electrical circuit. The dryer will start automatically.
The dryer may require up to 24 hours of operation to reach normal operating dew
points.
Therefore, indicators and/or alarms should not be considered until that time.
After start up, some dusting may occur. This will decrease afterwards.
ON / OFF:
The dryer should start automatically when connected to power supply.
If the dryer does not start automatically, use the procedure below:
-Push button to START the dryer.
-Push button
to STOP the dryer.
When the dryer is turned off, the display shows LED1 blinking (see chapter 5.1)
Summary of Contents for HGL 120
