CONFIG and then STORE buttons. Then use
◁
and
▷
buttons to move
between the digits and
▽
and
△
buttons to increase or decrease
numbers as desired. When ready, press ENTER button.
The default
number of readings will be restored when the meter has been turned
off.
The location of the buttons are shown with red rectangle frames in
Figure 4-28
.
Note: The MEM annunciator will be lit while the multimeter stores
※
readings and be turned off when the specified number of readings is
reached.
Procedures: STORE
→
<NUMBER>
Figure 4-28
To recall the stored readings, use the following steps:
Press RECALL button, and the multimeter will display all the stored
readings starting from the first reading. Use
◁
and
▷
or
▽
and
△
buttons to move from the first reading to the last reading the meter
has stored.
The locations of the buttons are shown with red rectangle
frames in
Figure 4-29
.
102