(COUNT), scan interval (TIMER) and store (STORE) options. Then press
ENTER on your selection. Use
◁
and
▷
to move through the digits and
△
and
▽
to increase or decrease the numbers to a desired value. For
STORE option, you can select ON to instruct the meter to store the
measurement results for later retrieving or select OFF .Press ENTER to
set the value.
How to open and close the channels
Press SHIFT + DIGITS for scanning configuration. Use
◁
and
▷
buttons to scroll through submenus. Press ENTER on “----”
when you need to close a specific channel. Press ENTER again on
“CHANNEL”. Use
◁
and
▷
to move through the digits and
△
and
▽
to
increase or decrease the numbers to the desired channel number.
Press ENTER to close the channel.
To open all channels, simply press ENTER on “OPEN ALL” option. Press
SHIFT + DIGITS to scan.
The locations of the buttons are shown with red rectangle frames in
Figure 4-31
.
Figure 4-31
4.4.6 Stepping (Step)
Stepping is scanning with a specified time delay between taking input
signal through the defined channels.
Note: Setting range of scanner card is only limited on DCV, DCI, ACV,
※
108
