5.
Not Used
32
Set to 0
6.
Not Used
64
Set to 0
7.
Not Used
128
Set to 0
8.
Not Used
256
Set to 0
9.
Ohms Overload
512
Range overload on 2-/4-wired ohm function.
10.
Not Used
1024
Set to 0
11.
Limit Failed at LO
2048
Reading is less than lower limit under limit test.
12.
Limit Failed at HI
4096
Reading is excess upper limit under limit test.
13.
Not Used
8192
Set to 0
14.
Not Used
16384
Set to 0
15.
Not Used
32768
Set to 0
The following conditions will clear the questionable data event register.
You execute a *CLS command.
You query the event register by using STATus:QUEStionable:EVENt?.
The following conditions will clear the questionable data enable
register.
You turn on the power without using *PSC command.
You execute the STATus:PRESet command.
You execute the STATus:QUEStionable:ENABle 0 command.
C.10 Status Reporting Commands
SYSTem:ERRor?
Query the multimeter’s error queue. Up to 20 errors can be stored in the
queue. Errors are retrieved in first-in-first out (FIFO) order. Each error
string may contain up to 80 characters.
STATus:QUEStionable:ENABle <enable value>
178
