the number of samples per trigger, the number of triggers per event,
reading hold, and the trigger delay for your measurements.
A. Number of samples on each trigger
By default, the multimeter takes only one reading on each trigger, but
you can instruct the multimeter to take specific number (up to 50000)
of readings each time it receives a trigger. The user’s input setting is
stored in a volatile memory which will be cleared after the meter has
been turned off and the default value will be restored. You can set the
number of samples on each trigger through front panel or the remote
interface.
Front Panel Operation
Press MENU button and locate “TRIG” submenu by pressing
◁
and
▷
buttons. Press ENTER to choose “TRIG” option. Again locate “N
SAMPLE” submenu using
◁
and
▷
buttons and then press ENTER to
select it. Then set the desired number by pressing
△
and
▽
buttons to
increase or decrease the number, and using
◁
and
▷
buttons to move
through the digits. The locations of these buttons are shown with red
rectangle frames in
Figure 4-11
.
Procedures: MENU
→
TRIG
→
N SAMPLE
→
<Number>
Figure 4-11
Remote Interface Operation
Use the following command to set the number of samples from your PC
terminal.
76
+
