target value. Press ENTER to set the value. Press % to activate this
function. And then observe the calculated percent value on the display
as shown as
Figure 4-15
.
※
Note: Press % again to disable this function. The “MATH”
annunciator on the display indicates the state of a mathematical
feature.
Figure 4-15
Remote Interface Operation
Use the following commands to enable and configure Percent function:
CALCulate:FUNCtion PERCent
CALCulate:STATe {OFF|ON}
CALCulate:STATe?
CALCulate:PERCent:TARGet {<
value
>|MINimum|MAXimum}
CALCulate:PERCent:TARGet? [MINimum|MAXimum]
4.3.3 Min/Max
Definition
When the Min/Max function is enabled, the multimeter takes in a series
of readings from the measurements, stores the minimum and
maximum readings in the memory, and then calculates the average
value of all readings. The number of readings taken since Min/Max
operation is enabled is recorded as well. These data are stored in a
83
