+46(0)20-220 220 • www.attract.nu
Attract Treadmill 1030
8
Activating the treadmill.
Put the electrical plug in a grounded wall outlet and then turn on the power switch on the front right
side of the treadmill (see picture 1) . As soon as the power is turned on a short sound is emitted that
means the product is in stand-by mode. Attach the safety strap magnet (see picture 2) in the round
hole on the front of the control panel. (The display shows “- - -” if you have not attached the safety
strap on the front of the display).
Starting the belt
When you feel ready and are standing on the treadmill:
Starting the belt
1. Press the start button,
The display counts down and beeps three times.
The belt starts at the lowest speed (0,8km/h),
the pre-set program time is 60 minutes.
Changing speed
There are several ways of changing speed.
1 Increase/decrease speed with the
t
/
s
on the control panel.
2. Increase speed with the +/- button on the handrail.
3. Go straight to 3, 5, 7km/h with the quick choice buttons
on the control panel.
Changing program time before starting in manual control mode.
1. Press the Mode button once (the display shows 30 minutes).
2. Select desired program time (total minutes) with the t/s
3. Press the start button, the display counts down and beeps
three times. The belt starts at the lowest speed (0,8km/h).
4. Select desired speed.
5. The display counts down from the selected time.
Choosing distance before start in manual control mode.
1. Press the Mode button twice (the display shows 1km)
2. Select distance (total km) with the
t
/
s
3. Press the start button, the display counts down and
beeps three times. The belt starts at the lowest speed (0,8km/h).
4. Select desired speed.
5. The display counts down from the selected distance
Using the twelve automatic programs P01-P12
1. Press the PROG button until the desired program
is shown in the display.
2. The pre-set time 30 minutes blinks in the display. Use the
t
/
s
to enter the desired time (5-60 minutes).
3. Press the start button. The automatic program starts after a
three second countdown.
START
STOP
3KM/H
PULSE
/CAL
5KM/H
7KM/H
SPEED
PROG
MODE
THE DISPLAY SHOWS:
SPEED, TIME, DISTANCE AND PULSE.
( To view estimated calorie burn
press PULS/CAL once, press once
to return to pulse view)
Picture 1
Picture 2
Summary of Contents for HMT-1030
Page 1: ...Attract TREADMILL HMT 1030 IMPORTANT Read the entire manual carefully before assembly and use...
Page 33: ...Attract TREADMILL HMT 1030 T RKE Lue k ytt ohjeet huolellisesti ennen asennusta ja k ytt...
Page 49: ...Attract TREADMILL HMT 1030 IMPORTANT Read the entire manual carefully before assembly and use...