+46(0)20-220 220 • www.attract.nu
Attract Treadmill 1030
11
Regular maintenance
Cleaning
Make sure that the treadmill and the area around and under it is clean. It is especially important
that the running belt, the side rails and also the floor under the belt are kept clean, so no dirt gets
between the running belt and the sliding surface or under the motor cover. Dirt and dust can quickly
result in increased wear, as well as damaging the machine. Vacuum the running belt and the sides
of the belt as needed or at least once a week, the rest can be wiped with a slightly damp cloth (a
mild soap solution is ok). To avoid getting water in electrical components, the treadmill should not
be cleaned with a wet cloth, swab or mop.
Silicone oil
To extend the life of the treadmill, lubricate regularly
(see below) with ATTRACT TREADMILL OIL.
This oil can be purchased from our distributors and our
web shop, www.attract.nu.
Lubricating with silicone oil: The treadmill comes lubricated when purchased. It should then be
lubricated about every 30th time it is used (or once every other month). Turn off the power, lift up
the rubber mat on the right side with one hand and spray silicone oil moderately along the whole
sliding surface under the mat. Do the same on the left side. Turn on the belt at its lowest speed and
walk for roughly three minutes so the silicone oil is evenly spread out.
Adjusting the running belt
Check that the belt is centred. If it is not, adjust the belt so that it runs freely (see below).
Check that the running belt is correctly centred between the back tail covers every time before
using the treadmill. Adjust the belt if needed, normally only a small adjustment is required. Screw
half a turn clockwise on the side that the belt is too near to, then test for at least 15 seconds at
4km/h (check and adjust a further quarter or half turn until the belt is centred).
NOTE:
the running belt should not be tightened too hard as this can cause noise and damage the machine.
Storage
Remember to store the treadmill in a dry place and not to pile things on top of it.
Anti-clockwise
Clockwise
Anti-clockwise
Clockwise
Picture 01: Screwing
clockwise moves the
mat to the right.
Screwing anti-clock-
wise moves
the running belt to
the left.
Picture 02: Screwing
clockwise moves
the mat to the left.
Screwing anti-clock-
wise moves
the running belt to
the right.
Summary of Contents for HMT-1030
Page 1: ...Attract TREADMILL HMT 1030 IMPORTANT Read the entire manual carefully before assembly and use...
Page 33: ...Attract TREADMILL HMT 1030 T RKE Lue k ytt ohjeet huolellisesti ennen asennusta ja k ytt...
Page 49: ...Attract TREADMILL HMT 1030 IMPORTANT Read the entire manual carefully before assembly and use...
