HAND-HELD DISPLAY MODULE
3-6
ChromaFlex Chassis – Operation Manual
ATX Confi dential & Proprietary
Greeting:
After a valid slot is selected from the option menu of Chassis, a greeting menu of the selected module will be shown; in this
case, it is “CCTX”.
Greeting Message
Setup Menu:
Mode Setting
Mode:
use the right or left bottom to toggle the mode to “AGC” or “MGC” mode.
Save:
use the right or left bottom to toggle the NVRAM mode to “Yes” to save and press select to store the setting
in the NV RAM.
NOTE: Failing to do so may result in the loss of the setting after a power cycle.
Gain Setting
RF Lvl(rdB):
current RF level reading in rdB (relative dB).
Gain:
use the right or left bottom to step up or down the gain.
Save:
use the right or left bottom to toggle the NVRAM mode to “Yes” to save and press select to store the setting
in the NV RAM.
NOTE: Failing to do so may result in the loss of the setting after a reboot/power cycle.
Tx Status Menu:
This display conveniently presents all available channels in one line.
Opt:
displays the optical output power in dBm to each ITU transmitter channel.
RF
: displays RF input level reading in dB to each ITU transmitter channel.
Attn
: displays the reading of reserve attenuation in dB.
Mode
: displayed the current mode AGC or MGC.
Alarm Menu: Displays the status of each ITU channel.
Use left/right buttons to select a particular transmitter ITU channel
for per channel items. Available channel numbers are 1 to 4 or highest available channel.
Laser Temp:
displays the alarm status of laser temperature.
Output Pwr
: displays the alarm status of the laser output power.
RF Level
: displays the alarm status of the RF level.
Module Temp:
displays the alarm status of module temperature.
Status Menu: Displays the status of each ITU channel.
Use left/right buttons to select a particular transmitter ITU channel
for per channel items. Available channel numbers are 1 to 4 or highest available channel.
Temp (C):
displays the reading of laser temperature in Centigrade.
Power (mW):
displays the reading of optical power in milliwatts.
Power (dBm):
displays the reading of optical power in dBm.
RF Lvl (dB)
: displays the reading of RF level in dB.
Lambda (nm)
: displays the reading of wavelength in nanometer.
Voltage (V)
: displayed the on board supply voltage.
ATX Networks
CCTX
CHAPTER 3: