CRAFT LINE INTERFACE (CLI)
ChromaFlex Chassis – Operation Manual
4-5
ATX Confidential & Proprietary
slot:
displays the detected plug-in module in each slot.
Example #1: This example shows that the chassis contains a CCT4 in slot 7 and all other slots are empty.
Note that the CCT4 is a dual slot module so it is shown populated in slot 7 & 8.
ChromaFlex[slot-1]
>slot
Slot 1 - Empty
Slot 2 - Empty
Slot 3 - Empty
Slot 4 - Empty
Slot 5 - Empty
Slot 6 - Empty
Slot 7 - CCTX
Slot 8 - CCTX
ModuleSupport
: displays the list of supported modules.
You can use this command to determine the compatibility of the
chassis and plug in modules. A Controller Module with an older version of software may require a software upgrade to
support a new type of plug in module.
Example #1: This example shows the list of supported modules. Note: The ChromaFlex will always be
shown as the chassis controller module is always present.
ChromaFlex
[slot-1]
>ModuleSupport
CCTX
EDFA
AGC-EDFA
DUAL-EDFA
DUAL-AGC-EDFA
ModelName:
displays all the model name information which can be supported by ChromaFlex Chassis Systems.
SerialNum:
displays the serial number information of the chassis controller module.
Network:
displays or set the chassis controller module network configuration.
Example #1: In this example, the controller module contains the configuration with an IP address:
192.168.1.202, network address mask: 255.255.255.0 and gateway address: 192.168.1.1.
ChromaFlex
[slot-1]
>network
IpAddr: 192.168.1.202 Mask: 255.255.255.0 Gateway: 192.168.1.1
BdCast: 192.168.1.255 Mac: 00:50:c2:88:10:02
Example #2: In this example, the controller module is configured with an IP address: 192.168.1.202,
network address mask: 255.255.255.0 and gateway address: 192.168.1.1. And the system indicates the
command execution as “Successful”. Only these network parameters are configurable by the user.
ChromaFlex [slot-1] >network 192.168.1.202 255.255.255.0 192.168.1.1
Successful
Download
: Initiate a remote system software upgrade.
CHAPTER 4: