FRONT PANEL LCD DISPLAY
TranScend Chassis – Operation Manual
4-27
Tx Fiber Length Menu:
Length (km):
Press “Select” to set the transmit fi ber length. Press “Right” or “left” button to increase or decrease
the fi ber length.
NOTE: User must press “Select” to select the fi ber length in order for the plug-in to operate at
selected fi ber length and for NVRAM storage. Fail to do so, the fi ber length might revert back to
previous setting.
The factory default:
10
Save:
Press “Right” or “Left” button to cycle between “Yes” or “No”. Press “Select” to commit the selection into
NVRAM when “Yes” is selected. The display in bracket refl ects the current NVRAM storage reading. If user presses
“Select” when display is “No”, no NVRAM change takes place.
Status Menu:
Laser Temp(C):
Displays the current reading of laser temperature in Centigrade.
Laser Pwr(dBm):
Displays the current reading of laser power in dBm.
TxRF Lvl(dB):
Displays the current reading of TxRF level in dB.
Lambda (nm):
Displays the laser wavelength in nano meter.
Tx Attn (dB):
Displays the current reading of transmit attenuation in dB.
Volt (V):
Displays onboard supply voltage.
Alarm Menu:
Laser Temp:
Displays the alarm status of the laser temperature.
Laser Power:
Displays the alarm status of laser power.
TxRF Level:
Displays the alarm status of TxRF level.
Module Temp:
Displays the alarm status of module temperature.
Chassis Menu:
Temp(C):
Displays the module’s temperature reading in Centigrade.
Model:
Displays the model name of plug-in module.
HW Ver:
Displays the hardware version information of plug-in module.
SW Ver:
Displays the software version information of plug-in module.
Ser #:
Displays the serial number of plug-in module.
Prev Menu:
Press “Select” will bring the plug-in’s greeting message screen back.
4.3.14 Opto-Stacker
Level 1
Level 2
Level 3
Level 4
Greeting
Setup
Sel Channel
Mode Setting
Mode
Save
Prev Menu
Attn Setting
Attn(dB)
Save
Prev Menu
Prev Menu
CHAPTER 4:
