MDU Solutions
®
– UCrypt
®
IP to QAM – Quick Start Guide
1-1
CHAPTER 1: SAFETY
SAFETY
1. SAFETY
WARNING! FAILURE TO FOLLOW THE SAFETY PRECAUTIONS LISTED BELOW MAY RESULT IN PROPERTY DAMAGE
OR PERSONAL INJURY. PLEASE READ AND COMPLY WITH THE FOLLOWING:
SAFETY GROUND:
The connection to earth of the supplementary grounding conductor shall be in compliance with the
appropriate rules for terminating bonding jumpers in Part V of Article 250 of the National Electrical Code, ANSI/NFPA 70, and
Section 10 of Part I of the Canadian Electrical Code, Part I, CSA C22.1.
WATER AND MOISTURE:
Care should be taken to prevent entry of splashed or dripping water, other liquids, and physical
objects through enclosure openings.
DAMAGE:
Do not operate the device if damage to any components is suspected.
POWER SOURCES:
Only connect the unit to a power supply of the type and capacity specified in the operating instructions
or as marked on the device.
NOTE:
a) For 115 VAC operation, use the power cord supplied for operation from a 115 VAC source.
b) For 230 VAC operation, use the power cord supplied for operation from a 230 VAC source.
GROUNDING OR POLARIZATION:
Electrical grounding and polarization means must not be defeated.
POWER CORD PROTECTION:
Care must be taken during installation to route or arrange the power supply cord to prevent
and avoid the possibility of damage to the cord by external objects. Pay particular attention to the exit point from the device
and plug.
POWER SUPPLY CORD ROUTING:
The power supply cord shall not be attached to the building surface, nor run through
walls, ceilings, floors and similar openings in the building structure.
SERVICE:
Do not attempt to service the device beyond procedures provided the operating instructions. All other servicing
should be referred to qualified service personnel.
MODIFICATIONS:
Modifications should not be made to the device or any of its components for applications other than those
specified in the operating instructions.
SAFETY CODES AND REGULATIONS:
The device should be installed and operated in compliance with all applicable local
safety by-laws, codes and regulations.
BATTERY REMOVAL AND REPLACEMENT:
Disconnect power (AC or DC) from the equipment before battery removal and
replacement. This is accomplished by unplugging the power cord from the power outlet. Replace the battery with Sony part
No. CR2032 or exact replacement only.
CAUTION:
Use of a different battery type may present a risk of fire or explosion.
BATTERY DISPOSAL:
Recycle or dispose of batteries in accordance with the battery manufacturer’s instructions and local/
national disposal and recycling regulations. Please call 1-800-8-BATTERY or go to the website at www.call2recycle.org for
information on recycling or disposing of your used battery.
