14
Getting started
The CMP30 player is designed for installation into a rack (482 mm / 19”) with a height of one
single rack space (44.45 mm), but it can also be placed as a desktop unit. Before using the device,
the connections of the CMP30 should be made properly. The audio output connections should be
made with the RCA/Cinch connectors on the rear side of the device. depending of the
application, the variable either the fixed Audio outputs should be used.
When the device is connected to a sound system where only one audio source will be used at a
time, the variable audio output should be used. When connecting the CMP30 to a Multi-Channel
amplifier or Pre-amplifier or when used in a Multi-Zone audio Matrix system, its recommended to
use the fixed audio outputs, so both CD/MP3 and Tuner audio sources can be used simultaneous.
After the audio connections are made, the mains power should be connected to the IEC input
connector and the FM antenna should be connected to the provided connectors.
After all connections are made properly, the device can be switched on by pushing the power
button. After the power button is pressed, the device will start working after some seconds.
To start playing music from CD/MP3, insert a CD, USB storage device or SD/MMC memory
card to the slots on front of the device. When the media is inserted, the device will detect
automatically and will start playing. You can select the playing tracks using the control buttons on
front of the device. For switching to settings of another media source, press the function dial on
front (The variable audio output will switch automatically to this media source).
The preferred radio station can be selected by pressing the
and
buttons. When
pressing those buttons one time, it will search automatically to the previous or next radio station.
When holding one of those buttons for three seconds, it will return to manual seek mode and you
can select the radio station manual.
Chapter
3
Summary of Contents for CMP30
Page 17: ...16 Personal notes ...
