AUDAC MSP40, User Manual

11

Rear Panel overview 
 

Rear panel description

AC Power inlet with fuse:

The mains power supply (100-240V AC - 50/60 Hz) has to be applied to this AC power 
inlet. The connection is made by an IEC C14 power connector and is fitted with a fuse. When 
replacing the fuse, make sure that the value of the replacement fuse matches the value of 
the original fuse. (T0.5AL/250V)

RS232 Connection:

The RS232 connection can be used to control the system through any external hardware 
such as home and industrial automation systems. The pinout and communication settings 
are described in an earlier chapter of this user manual. The complete RS232 command 
instruction set and configuration information can be downloaded from the AUDAC website.

USB (Update) Connection:

The USB (Update) connection can be used for system firmware updates and/or for connection 
of the RF remote control (RMT40) receiver.

Balanced stereo line output:

The balanced stereo line output is implemented using two 3-pin terminal block connectors. 
The audio output available on this connector allows it to be fed to any amplifier or pre-amplifier.

Balanced stereo record input:

The balanced stereo line input (recording input) is implemented using two 3-pin terminal 
block connectors. The line level audio signal coming from the audio source or pre-amplifier 
shall be connected to this connector, allowing it being recorded.