10
7) POWER switch
Use this switch to turn the SX408A on and off. The signal LED lights up green to indicate when
the SX408A is powered up.
Note:
The cabinet will automatically turn off when there is no signal present on the input (after
about 30 seconds).
8) MAINS power connection
This is where you connect the AC line cord to provide AC power to the SX408A’s integrated
amplifier. The input connection is performed using IEC power connectors.
The SX408A is factory default set to be used on 220 – 240 Volt AC mains networks. But it can be
switched to be used on 110 – 120 Volt AC mains networks.
To change the SX408A to be used on 110 – 120 Volt, you
have take out the fuse compartment, and turn it over. To
make sure it is set to the right mains voltage, check if the two
arrows on the fuse department match with the right voltage.
Replace the fuse of the SX408A only with a fuse that matches
the specifications of the original one. (T4A / 250V)
FUSE
220-240V
110-120
V
Summary of Contents for SX408A
Page 12: ...11 Block Diagram Chapter 3 ...
Page 16: ...15 Personal notes ...
