4
Set-Up
1. Open the rear of your Test Signal Generator (see
diagram on the right) and insert two alkaline AA
batteries.
2. Plug the XLR connection lead into the line input
of the hearing loop driver being tested.
3. Press the power/pause button to turn on the
Test Signal Generator (see diagram below).
4. Press the power/pause button to switch
between frequencies.
Frequency
Indicator
Power/Pause Button
& Frequency Change
XLR
Connection Lead
5. To turn off the device, hold the power/pause button down for three
seconds.
Summary of Contents for DCTSG1
Page 1: ...Test Signal Generator DCTSG1 User Guide February 2017 ...
Page 6: ...6 ...
Page 7: ...7 ...
