18
TROUBLESHOOTING
Symptom Cause Remedy
Power cord incorrectly plugged
Make sure the power cord is correctly
plugged into the amplifier and into the
wall outlet
Display is off
No sound
Burned-out fuses
Check fuses in the fuse panel (after
unplugging the power cord from the
wall outlet) above the IEC power inlet
and replace them with new ones of the
same type
Volume knob completely rotated anti-
clockwise
Rotate the volume knob clockwise
Faulty or incorrectly plugged
connectors between frames
Check that the three cords that
connect the frames are correctly
plugged
Power amplifier is off
Turn power amplifier on
Faulty or incorrectly plugged
connectors between Maestro Line
Preamplifier and the amplifier
Check cords and their connection
Faulty or incorrectly selected sound
source
Check that the sound source is on and
correctly selected through the ins
selector
Display is on
No sound
Faulty or incorrectly plugged
connectors between Maestro Line
Preamplifier and the selected sound
source
Check cords and their connection
Recording is impossible
Incorrectly selected source
Select the right source using the
recording selector
No battery/ worn-out battery
Place/replace battery (2 ‘AAA’
batteries)
Remote controller doesn’t work
You’re standing too far or on an
exceeding angle from the front panel
Get closer to the unit or reduce angle
If the suggested remedies should not work or the problem is not shown in the list above, please contact your
local Audio Analogue retailer.
