8
9
3.4 INSTALLING THE CAT 5 TRANSMITTER
• Mount the 1180T or 1180TD Transmitter and connect component video and
audio cables from the source equipment to the inputs of the Transmitter.
• Plug the Cat 5 cable into an output jack on the Transmitter (either or both may
be used), and power up the A/V equipment connected at each end.
• Power the SCP-11 system (install a receiver power supply if the Cat 5 cable is
over 700 feet long).
• Fine tune the cable length compensation at receiver location(s) to optimize
picture quality.
CAT 5e/6 CABLE TO RECEIVER(S)
CONNECT VIDEO AND/OR AUDIO
TO TV AND RECEIVER
CONNECT POWER SUPPLY
Transmitter
Connections
The 1180T is pictured, but the
connections and adjustments
are similar for the 1180TD
wallplate transmitter.
Wallplate version
connections (not
shown) are similar.
4.0 ADAPTING DUAL CAT 5 SYSTEMS USING MODEL 1110
Model 1180R and 1180RD may be used with the AVAtrix or other compatible
Audio Authority two-wire Cat 5 systems such as the SixDrive and DuoDrive. The
Model 1110 adapter must be used to connect each dual Cat 5 output to each
single Cat 5 receiver.
• The 1110 routes the YPbPr and digital audio signal pathways to the correct
Cat 5 pairs for the receiver, but does not pass analog audio.
• The 1110 outputs IR signals to a separate 3.5 mm jack.
• Power is also delivered to the receiver through the 1110, but remember that
cable lengths over 700 feet still require power at the receiver end.
• Always test Cat 5 cables before powering the system – even pre-fabricated
cables should be tested for proper pairing – continuity testing is not adequate!
