SDS-1001-101-x Installation Manual
Document #540306, Rev IR, 04/2005
Page 5 of 12
3.1.2 The module shall be installed to conform to the standards
designated by the customer, installing agency, or other specified
requirements.
3.1.3 Select a mounting location for the Serial Digital A/V Splitter before
installation. Refer to Section 7.0 for dimensions and attachment
points. The unit shall be bonded to the aircraft frame with a
bonding resistance of less than 0.01
Ω
.
3.2
Unpacking and Inspection
3.2.1 Carefully open the packaging and remove the unit. Verify that all
components have been included in the package per the packing
list. Inspect the unit for shipping damage.
3.2.2 If damage has occurred during shipping, a claim should be filed
with Audio International WITHIN 24 hours and a
Return Request
Authorization Number
shall be obtained from AI by contacting the
Repair Department at 501.801.0640. Repackage the unit in its
original packaging materials and return it to AI following instructions
given by the AI representative. Refer to the front cover of this
manual for address. If no return is necessary, retain the packing
list and the packing materials for storage.
3.3
Cautions & Warnings
3.3.1 It is important to do a pin-to-pin power and ground check on all
connectors. Ensure that power and ground are applied only where
specified. Damage to the unit can result if power or ground is
applied to the wrong points.
3.3.2
DO NOT
connect or disconnect the unit while power is applied.
3.3.3
DO NOT
connect or disconnect any inputs or outputs when power
is applied to the unit.
3.3.4
DO NOT
remove any factory-installed screws. Damage to the unit
can result and void any warranties.
3.3.5
ESD
(Electro Static Discharge) guidelines shall be followed.
