VCP-010-06(-07)-x Installation & Operation Manual
Document # 540236, Rev IR, 11/2002
Page 19 of 21
SECTION III – OPERATION
1.0 General
Information
1.1 The VCP-010-06(-07)-x can be operated via front panel ‘buttons’ or
optionally controlled by infrared remote or AI’s touch screen panel. Digital
codes allow the unit to interface with an infrared handheld remote via an
infrared receiver, IFR-9A or IFR-485.
1.2
Utilizing the infrared inputs, the VCP-010-06(-07)-x can be configured to
accept up to four (4) different sets of infrared codes or eight (8) separate
RS-485 addresses. This allows up to four (4) of the same devices when
using infrared inputs or eight (8) of the same devices when using the
RS-485 data bus to be used in the same system while maintaining
independent control. Three (3) strap pins are available to configure the
infrared codes and RS-485 addressing. Standard configuration requires
no strap pins to be connected. To change the code settings, connect one
(1) of the strap pins to the strap common.
1.3 Playback options with front ‘button’ controls, remote, or touch screen
controls include stop, eject, fast-forward, rewind, and pause.
1.4
When the VCP-010-06(-07)-x reaches the end of the videocassette, the
unit will automatically enter rewind mode. As a safety precaution, the
VCP-010-06(-07)-x has been designed so that it will not automatically
eject when the tape has been fully rewound. The EJECT button on the
front panel must be pressed to unload the videocassette tape.