AEW-R4100
Audio-Technica U.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224
Audio-Technica Limited, Old Lane, Leeds LS11 8AG England
©2010 Audio-Technica U.S., Inc. audio-technica.com
0001-0017-01
In the interest of standards development, A.T.U.S. offers full
details on its test methods to other industry
professionals on request.
Specifications are subject to change without notice.
UHF SYNTHESIZED DIVERSITY RECEIVER AEW-R4100
ALERT
MODE/SET
POWER
ON
OFF
PHONES
IN
OUTPUT
(UNBAL.)
INSTRUMENT
0/-6/-12
ATTN (dB)
BALANCED
MIC OUTPUT
GROUND
LIFT
GROUND
IN – LINK – OUT
IN
ANT. A
WARNING:
THIS APPARATUS MUST BE EARTHED.
AC
˜
100V-240V
50/60Hz
MIN–
LEVEL
–MAX
ANT. B
RX NAME
front
back
Specifications
Overall system
Band C: 541.500–566.375 MHz;
Band D: 655.500–680.375 MHz
996 total per band (25 kHz increments)
±0.005%, Phase Lock Loop frequency control
FM
±5 kHz
300' typical
5° C (41° F) to 45° C (113° F)
70 Hz to 15 kHz
AEW-R4100 receiver
Dual independent RF sections, automatic-
switching diversity
60 dB typical
115 dB at 40 kHz deviation (IEC-weighted),
75 kHz maximum modulation
≤1% (10 kHz deviation at 1 kHz)
20 dBµV (S/N 70 dB at 5 kHz deviation,
IEC-weighted)
65.75 MHz, 10.7 MHz
Microphone: 25 mV (at 1 kHz, ±5 kHz devia-
tion, 10k ohm load),
Instrument: 50 mV (at 1 kHz, ±5 kHz devia-
tion, 10k ohm load)
Three-position switch: 0 / –6 / –12 dB
Microphone: XLRM-type, (balanced);
Instrument: 6.3 mm (
1
/
4
") TS unbalanced
phone jack
Connector: 6.3 mm (
1
/
4
") TRS (“stereo”)
phone jack; Power output: 10 mW + 10 mW
at 1 kHz, ±5 kHz deviation into 32 ohms;
maximum output, 220 mW + 220 mW into
32 ohms
DC 10V-12V, 20 mA (BNC-type jack)
100-240V AC 50/60 Hz, 8W
211.0 mm (8.31") W x 44.0 mm (1.74") H x
235.0 mm (9.26") D
1.7 kg (3.8 lbs) (without accessories)
Detachable IEC-type AC power cable; two
flexible UHF half-wave antennas; link cable;
rack-mount adapters
UHF operating frequencies
Number of frequencies
Frequency stability
Modulation mode
Normal deviation
Operating range
Operating temperature range
Frequency response
Receiving system
Image rejection
Signal-to-noise ratio
Total harmonic distortion
Sensitivity
Intermediate frequency
Audio output (attn switch at “0”)
Audio output attenuator (ATTN)
Output connectors
Headphone output
Antenna power
Power supply
Dimensions
Net weight
Accessories included
47
