8
Specifications
Communication system
Bluetooth Ver. 3.0
Output
Bluetooth Specification Power Class 2
Maximum communication range
Line of sight - approx. 10m
Compatible
Bluetooth
profile
A2DP
Support codec
SBC
Type
Belt drive turntable, fully automatic
Platter
Aluminum
Motor
DC servo-controlled
Speeds
33
1
/
3
RPM, 45 RPM
Wow and flutter
Less than 0.25% (WTD) @ 3 kHz (JIS)
Signal-to-noise ratio
>50 dB (DIN-B)
Cartridge
Integral Dual Moving Magnet
™
stereo cartridge with diamond stylus
Output level
Pre-amplifier “PHONO”
2.5 mV nominal at 1 kHz, 5 cm/sec
Pre-amplifier “LINE”
150 mV nominal at 1 kHz, 5 cm/sec
Phono pre-amplifier gain
36 dB nominal, RIAA equalized
Power
220 to 240V AC, 50/60 Hz, 3W (Europe)
Dimensions
360.0 mm (14.17") W x 97.5 mm (3.84") H x 356.0 mm (14.2") D
Net weight
2.98 kg (6.6lbs.)
Accessories
3.5 mm (1/8") mini-plug (male) to dual RCA (male) stereo output cable, 45 RPM adapter, Removable hinged
dust cover
Replacement stylus
ATN3600L
• The
Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Audio-Technica Corporation is under license.
All other trademarks are property of their respective owners.
•
For product improvement, the product is subject to modification without notice.
Tips For Better Performance
• When opening or closing the turntable cover, handle it gently,
moving it either at the center or equally from both sides.
•
Do not touch the stylus tip with your fingers; avoid bumping
the stylus on the turntable mat or a record’s edge.
•
Clean the stylus tip frequently, using a soft brush
with a
back-to-front motion only.
•
If you use a stylus cleaning fluid, use it
very sparingly.
•
Wipe the dust cover and turntable housing gently with a soft
cloth. Use only a small amount of mild detergent solution to
clean the turntable and dust cover.
•
Never apply harsh chemicals or solvents to any part of the
turntable system.
•
Prior to moving the turntable, always unplug it from the AC
outlet and fasten the tone arm on the tone arm rest with the
vinyl twist-tie.
Specifications
