Installation & Maintenance Manual
11. Installing and Configuring the SBA
Version 6.8
85
Microsoft Lync Server
11.2 Step 2: Change Computer Name
The Change Computer Name option defines the computer name of the SBA.
Note:
•
This procedure requires you to reboot the SBA server to successfully apply the
configuration. However, if you forget to do so, the server automatically reboots after a
session timeout. When this occurs, the login screen appears with the following popup
message: "The SBA server needs to be rebooted. Please insert your credentials and
click on Login. The server will then be rebooted". After the server reboots, the
following message appears: "The SBA server has been rebooted automatically". You
can then login to the SBA Management Interface.
•
Once you join to the Domain, this configuration option is only available when you login
as a local user (not a Domain user).
To change the computer name of the SBA server:
1.
Select the
Setup
tab, and then select the 'Change Computer Name' check box; the
following screen appears:
Figure
11-7: Change Computer Name Screen
2.
In the 'Computer Name' field, enter the computer name.
Note:
The Computer Name must be the same as that used for the SBA in the Microsoft
Active Directory (AD) and Topology during the pre-configuration steps performed at the
datacenter (see Chapter
on page
on page
Summary of Contents for Mediant 1000B SBA
