4
|
P a g e
Powering the Device
The device provides two hot swappable Power Supply modules, providing load sharing and 1+1 power
redundancy in case of failure in one of the Power Supply modules. Depending on ordered power type, the
device is powered from a standard alternating current (AC) electrical wall outlet or from a direct current (DC)
power source.
Protective Earthing (Grounding)
The device must always be earthed (grounded). Connect an electrically earthed strap of 16-AWG wire
(minimum) to the chassis' grounding lug screw (located on the rear panel), and then connect the other end of
the strap to protective earthing.
Connecting to an AC power source:
1.
Insert the female socket, on one end of the power cord (supplied), into the AC inlet of one of the Power
Supply modules, located on the rear panel.
2.
Insert the plug, on the other end of the power cord, into the AC electrical wall outlet.
3.
Repeat the above steps for the second Power Supply module, but connect it to a different AC power
source.
