Version 6.6
19
April 2012
Hardware Installation Manual
4. Mounting the Device
4
Mounting the Device
The device can be mounted in one of the following ways:
On a desktop – see Section
Installed in a standard 19-inch rack – see Section
on page
4.1
Desktop Mounting
The device can be mounted on a desktop, by attaching the supplied four adhesive, anti-
slide rubber feet to the underside of the device. Once you have attached these rubber
bumpers, you can place it on a desktop where the bumpers are in contact with the surface.
Figure
4-1: Underside of Device with Rubber Foot
To apply the anti-slide rubber bumpers to the device:
1.
Flip the device over so that its underside faces up.
2.
Locate the four anti-slide grooves on the device's underside–one in each of the four
corners, as shown in the figure below:
Figure
4-2: Location of Grooves for Rubber Bumpers
3.
Peel off the adhesive, anti-slide rubber bumpers and stick one in each anti-slide
groove.
4.
Flip the device over again so that it is resting on its underside and the rubber bumpers
are in contact with the surface.
