Version 6.2
143
February 2011
SIP User's Manual
3. Web-Based Management
4.
From the 'Profile Preference' drop-down list, select the priority of the Tel Profile, where
'1' is the lowest priority and '20' is the highest. If both IP and Tel profiles apply to the
same call, the coders and other common parameters (noted by an asterisk in the
description of the parameter TelProfile) of the preferred Profile are applied to that call.
If the Preference of the Tel and IP Profiles is identical, the Tel Profile parameters are
applied.
Note:
If the coder lists of both IP and Tel Profiles apply to the same call, only the
coders common to both are used. The order of the coders is determined by the
preference.
5.
Configure the Profile's parameters according to your requirements. For detailed
information on each parameter, refer to the description of the "global" parameter.
6.
From the 'Coder Group' drop-down list, select the Coder Group (see ''Configuring
Coder Groups'' on page
) or the device's default coder (see ''Configuring Coders''
on page
) to which you want to assign the Profile.
7.
Repeat steps 2 through 6 to configure additional Tel Profiles (optional).
8.
Click the
Submit
button to save your changes.
9.
To save the changes to flash memory, see ''Saving Configuration'' on page
3.3.2.10.4 Configuring IP Profiles
The 'IP Profile Settings' page allows you to define up to nine IP Profiles. You can later
assign these IP Profiles to other configuration entities:
Outbound IP Routing Table (see ''Configuring Outbound IP Routing Table'' on page
Inbound IP Routing Table (see ''Configuring Inbound IP Routing Table'' on page
IP Group (see ''Configuring IP Groups'' on page
The 'IP Profile Settings' page conveniently groups parameters according to application to
which they pertain:
Common Parameters: parameters common to all application types
Gateway Parameters: parameters applicable to gateway functionality
SBC Parameters: parameters that are applicable only to the SBC application
Notes:
•
For a detailed description of each parameter, refer to its corresponding
"global" parameter (configured as an individual parameter).
•
IP Profiles can also be implemented when operating with a Proxy server
(when the parameter AlwaysUseRouteTable is set to 1).
•
You can also configure IP Profiles using the
ini
file table parameter
IPProfile (see SIP Configuration Parameters).
Summary of Contents for Mediant 800 MSBG
