Version 6.6
513
MP-11x & MP-124
User's Manual
43. Configuration Parameters Reference
Parameter
Description
fax/modem signals are detected during the call.
Note:
This parameter is applicable only if G.711 VBD coder(s) are
selected for the device (using the CodersGroup parameter).
[FaxVBDBehavior]
Determines the device's fax transport behavior when G.711 VBD coder
is negotiated at call start.
[0]
= (Default) If the device is configured with a VBD coder (see the
CodersGroup parameter) and is negotiated OK at call start, then
both fax and modem signals are sent over RTP using the bypass
payload type (and no mid-call VBD or T.38 Re-INVITEs occur).
[1]
= If the IsFaxUsed parameter is set to 1, the channel opens with
the FaxTransportMode parameter set to 1 (relay). This is required to
detect mid-call fax tones and to send T.38 Re-INVITE messages
upon fax detection. If the remote party supports T.38, the fax is
relayed over T.38.
Notes:
If VBD coder negotiation fails at call start and if the IsFaxUsed
parameter is set to 1 (or 3), then the channel opens with the
FaxTransportMode parameter set to 1 (relay) to allow future
detection of fax tones and sending of T.38 Re-INVITES. In such a
scenario, the FaxVBDBehavior parameter has no effect.
This feature can be used only if the remote party supports T.38 fax
relay; otherwise, the fax fails.
Web: SIP Transport Type
EMS: Transport Type
[SIPTransportType]
Determines the default transport layer for outgoing SIP calls initiated by
the device.
[0]
UDP (default)
[1]
TCP
[2]
TLS (SIPS)
Notes:
It's recommended to use TLS for communication with a SIP Proxy
and not for direct device-to-device communication.
For received calls (i.e., incoming), the device accepts all these
protocols.
The value of this parameter is also used by the SAS application as
the default transport layer for outgoing SIP calls.
Web: SIP UDP Local Port
EMS: Local SIP Port
[LocalSIPPort]
Defines the local UDP port for SIP messages.
The valid range is 1 to 65534. The default value is 5060.
Web: SIP TCP Local Port
EMS: TCP Local SIP Port
[TCPLocalSIPPort]
Defines the local TCP port for SIP messages.
The valid range is 1 to 65535. The default value is 5060.
Web: SIP TLS Local Port
EMS: TLS Local SIP Port
[TLSLocalSIPPort]
Defines the local TLS port for SIP messages.
The valid range is 1 to 65535. The default value is 5061.
Note:
The value of this parameter must be different from the value of
the parameter TCPLocalSIPPort.
Web/EMS: Enable SIPS
[EnableSIPS]
Enables secured SIP (SIPS URI) connections over multiple hops.
[0]
Disable (default)
[1]
Enable
When the SIPTransportType parameter is set to 2 (i.e., TLS) and the
parameter EnableSIPS is disabled, TLS is used for the next network
Summary of Contents for MediaPack MP-112
