SIP Hardware Installation Manual
12
Document #: LTRT-94701
3000 Series Gateways & Media Servers
Modules:
•
Two Power Supply modules (PS/DC/3K) located on the right side of the front
panel (refer to PS/DC/3K Power Supply Modules).
•
One Fan Tray module (FM/M3K) located on the left side of the front panel (refer
to ''Chassis Cooling System'' on page
•
One Air Filter (AF/3K) located within the Fan Tray unit (refer to ''Chassis Cooling
System'' on page
•
Two Power Entry Modules (PEM/DC/3K) located on the left side of the rear panel
(refer to Power Entry Module (PEM/DC/3K)).
ID Prom component for defining hardware versions of the various modules.
DIP switch for configuring the shelf’s geographical address.
The main components of the device's front panel are shown below:
Figure
2-1: Front Panel Main Components
Table
2-2: 3000 Series Front Panel Component Descriptions
Item #
Component Description
1
Electrostatic discharge (ESD) terminal.
2
Fan Tray module (housing Air Filter), with system alarm LEDs,
ACO
button, and
component location diagram indicating numbering of blade slots and Power Supply units.
3
Latches and screws for securing modules/blades to chassis.
4
Power Supply units (two for load sharing).
5
Power Supply LEDs.
6
Integral mounting brackets for mounting in a standard 19-inch Telco rack.
7
Blade slots (currently covered with blank panels) for housing communication blades (6310
or 8410 series blades, and SA/M3K Alarm and Status blades).
