Version 5.4
19
May 2008
SIP Hardware Installation Manual
2. Physical Description
LED
Color
Status
Description
Green
On
Initialization completed successfully (i.e., normal functioning
of the chassis hardware).
SHELF
Red
On
(Default when device powered on) Undergoing initialization
(or failure of the chassis hardware).
2.3 6310
Blade
The 6310 blade is a member of AudioCodes’ 6310 series TrunkPack cPCI VoP
communication platform. The blade is a high-density, hot-swappable, cPCI resource blade
(form factor 6U PICMG 2.16) with a capacity of up to 2,016 DS0 channels, supporting all
necessary functions for voice, data, and fax streaming over IP networks. The blade is
considered a complete gateway / media server module. The blade occupies one slot of a
cPCI chassis, and features its own MAC and IP address. In addition, the blade provides
automatic protection switching (APS) capability (1+1) for STM-1/OC-3 PSTN interfaces.
The blade is housed in the chassis' front-panel slot, providing an RS-232 port, a reset
button, and various LEDs.
Figure
2-6: 6310 Blade
The blade is supplied with a rear input/output (I/O) module referred to as the
Rear
Transition Module
(RTM). The RTM-6310 provides the I/O connections to the supported
interfaces: IP, and one STM-1/OC-3 or three T3 PSTN interfaces. For a detailed
description of the RTM-6310, refer to ''RTM-6310 Rear Transition Module''
on page
For Mediant 3000 systems, the blade is designed for protection capabilities. The redundant
RTM (RTM-6310 Redundant), housed in the rear panel, provides 6310 blade redundancy
protection by routing all calls between the active blade (previously redundant) and the
RTM. The RTM-6310 Redundant itself does not provide any PSTN ports. For a detailed
description of the RTM-6310 Redundant, refer to ''RTM-6310 Redundancy Rear Transition
Module'' on page
Notes:
•
PSTN APS is partially compliant to GR-253 only.
•
The 6310 blade supports either STM-1/OC-3 or T3 PSTN interface,
depending on software configuration (using the PSTNTransmissionType
ini
file parameter).
•
HA (i.e., blade protection) is applicable only to Mediant 3000 systems.
