Phone 425-775-8461 • Fax 425-778-3166
®
53
tm
Cannot select Dolby Digital or DTS decoding mode
The Maestro M2e can only decode formats encoded onto
the source. Normally these are marked on the packaging
or liner notes of the material.
Verify that the correct format is selected in the Start
menu of the DVD.
Verify that the digital input from the source is properly
connected to the Maestro M2e.
Verify that the digital output of the source is enabled.
Some DVD players have a setup menu that can only be
accessed if there is no disk in the player.
Hum on analog inputs
Verify that all the two channel analog audio cables are
connected properly.
If the hum only occurs on one source, try a different set
of connecting cables.
If the hum occurs on a source with an external connec-
tion such as an antenna or cable TV, try disconnecting
that input. If the hum disappears, put a ground isolator
on that connection.
Try switching the ground lift switch on the back panel of
the Maestro M2e.
No Zone 2 audio when playing a DTS encoded video
Most DVD players cannot output a stereo analog version
of the soundtrack while playing a DTS encoded disk. If
you want to watch the movie in the second zone, select
the Dolby Digital soundtrack on the disk.
Unable to adjust the Bass and Treble controls
The Bass and Treble tone controls are defeated.
No Digital Audio On Active Balanced Outputs
Confirm that the “Remote Power/Digital Audio” button on
the back panel is in the “Out” position.
If you are using a BVR-25, active balanced receiver, make
sure that the rear jumpers on the BVR-25 are in the “A/V
position”.
Troubleshooting
Summary of Contents for Maestro M2e
Page 2: ......
Page 14: ...Phone 425 775 8461 Fax 425 778 3166 14 tm Guided Tour of the MasestroM2 ...
Page 18: ...Phone 425 775 8461 Fax 425 778 3166 18 tm MaestroM2etm Set Up Configuration ...
Page 50: ...Phone 425 775 8461 Fax 425 778 3166 50 tm ...
