Pre-Power mode
The pre-amplifier section is internally disconnected from the power amplifier. The
6000A Play can be used as a stand alone power amplifier (ie. part of an AV setup).
This mode can also be used if additional signal processing is required, connecting
the pre-out to an external signal processor and then take the output from the
processor to the 6000A Play Power-IN.
Operating Mode
Although the 6000A Play is an integrated amplifier it can function as a
separate pre and power amplifier.
Use the MODE knob on the front panel, or the MODE key on the remote
control, to select different operating modes.
MODE
POWER AMP IN
PRE OUT
HEADPHONE OUT LOUDSPEAKERS
PRE
DISABLE
ACTIVE
ACTIVE
DISABLE
PRE-POWER
ACTIVE
ACTIVE
ACTIVE
ACTIVE
INTEGRATED
DISABLE
ACTIVE
ACTIVE
ACTIVE
Pre Mode
All signals to and from the power amplifier of the 6000A Play are disconnected.
In this mode, the 6000A Play functions as a stand-alone pre-amplifier. The pre-
amplifier section of the 6000A Play can be connected to a stereo power amplifier,
or to two mono-block amplifiers.
Integrated Mode
The pre-amplifier section is internally connected to the power amplifier, pre-amplifier output is
also operational in this mode. A second power amplifier can be connected for bi-amplification
as shown in the diagram.
Page 9
7: System Operations - 2
Summary of Contents for 6000A Play
