18
Note
·
Microsoft Windows converts every input format automatically into a
stereo PCM signal with 44.1 or 48 kHz sampling frequency and
16 bits resolution. Which audio formats are played back depends on
the capabilities of your Microsoft Windows system and/or your
sound application only!
·
All volume and balance settings of Microsoft Windows or your sound
application will be still active. In case you hear no sound at all or the
sound has low volume while playing back sound and music files with
your ART G2, please make sure that your volume settings of your
Windows system are not muted or set to a low level.
Important
·
The USB Audio function of the ART G2 can
only
be used if the
loaded disc is stopped, or
no
disc is loaded at all.
·
During playback of any disc with the ART G2 you will hear
only
the
audio from the disc. There will be
no
signal from the USB Audio in-
terface.
·
Option
Set Auto Off
in the Global Setup menu has to be set to
never off
, if you would like to use the USB Audio function of the
ART G2, otherwise the unit will shut down automatically after 30
minutes (refer to section '
Set AutoOff
' on page 56).
In case you like to check, if Microsoft Windows recognized your
ART G2 correctly, please open up the Device Manager of your Windows
system. You will find the ART G2 in the following 3 places in the list of
devices:
Sound, video and game controller
→
USB Audio Device
Human Interface Devices
→
USB Human Interface Device
Universal Serial Bus controllers
→
USB Composite Device
The diagram on the following page gives an overview of an example list
of entries in the Device Manager:
