14
Note
·
Of course, you may switch on/off the CAT with the Audionet System
Remote Control
Harmony One
. For detailed information please refer
to section '
Audionet System
Remote Control' on page 33.
·
All user and setup options, presets, current receiver mode and fre-
quency are saved during power down and are available after switch-
ing on again. The last mode before switching off to stand by mode
will be restored. All saved information is non-volatile even after dis-
connecting the CAT from mains power
6.3 Mains phase detection
The correct polarization of mains is important for reasons of audio clarity
and stability. Please connect the mains cord so that the 'hot' pin of the
wall outlet is connected to the pin marked
phase
10 of the mains input
9 on the back panel. The CAT recognizes the incorrect polarization of
the mains plug automatically. Right after switching on the unit from
stand-by mode by pressing the
power
key on the front panel the follow-
ing message appears in the display in case the mains polarization is incor-
rect:
Attention: Mains
Phase incorrect!
If you read the above message, switch off the unit by pressing the
power
key. Please wait until the display no longer reads
GOING TO SLEEP..
Disconnect the CAT from mains by operating the mains switch 11 on
the back panel. Now pull the mains plug and re-insert it into the mains
socket rotated by 180°.
If you switch on the unit again, the warning should not appear now.
Important
·
If the CAT issues the mains polarization warning or no warning at all
for both positions of the mains plug, check the connection to earth of
your mains socket and mains cord.
You have to ensure a stable
connection to earth for the mains phase detection of the CAT to
work correctly!
Summary of Contents for Cat
Page 1: ...1 FM AM Stereo Tuner User s Manual ...
Page 2: ...2 ...