30
8.5 Set FM-Input
Adjust the sensitivity of the FM receiver according to the signal strength
of the input signal (antenna signal). Two settings are available.
Press key
up
on the front panel or key
Ch+
of the Audionet System
Remote control
Harmony One
to configure the CAT for high level input
signals (e.g. cable radio). The display shows
Cable
.
Press key
down
on the front panel or key
Ch-
of the Audionet System
Remote Control
Harmony One
to configure the CAT for low level inputs
(e.g. FM antenna). The display shows
Aerial
.
Note
·
This function is only available in FM reception mode.
8.6 Search Level FM
There are three settings available to adjust the threshold of the automatic
search function (see section '
Automatic search
' on page 17). The greater
the threshold, the stronger the signal of a station has to be in order to be
detected by the automatic search function and to stop the search. Use the
up
or
Ch+
key to increase the threshold. Press key
down
or
Ch-
to
decrease the threshold.
The three threshold levels
70 dBu
,
80 dBu
and
90 dBu
are available.
Note
·
This function is only available in FM reception mode.
·
If the automatic search function (see section '
Automatic search
' on
page 17) stops too often without finding a suitable station, increase
the threshold. If not all expected stations are found by the search
function, decrease the threshold.
·
The threshold for the automatic search function is only adjustable for
FM reception mode. While in AM reception mode the threshold is
fixed.
Summary of Contents for Cat
Page 1: ...1 FM AM Stereo Tuner User s Manual ...
Page 2: ...2 ...