23
Note
•
The activation signal is passed to further Audionet units daisy chained to the
Audionet Link output of your PLANCK with a slight delay to avoid all units
powering up at the same time – preventing an overload of your mains fuse.
First the control output OUT 1 and afterwards OUT 2 is activated.
•
The PLANCK may still be switched on or off manually at any time by using
the key on the front panel or the remote control.
Important
•
If the option
Set AutoOff
has the value
shut off in 30 min
, the
PLANCK will power down to stand-by mode automatically 30 minutes after
the disc has stopped or after a key is used on the front panel or remote
control. This function is independent from a preamplifier connected via Au-
dionet Link, i.e. the PLANCK shuts down automatically even if the preampli-
fier is still switched on (refer to section 'Set AutoOff' on page 51).
6.2
Inserting and removing discs
Open the cover on top of the PLANCK by pushing backwards using the handle.
Set a disc onto the spindle with the printed side facing upwards. Fix the disc with
the included stabilizer ('Puck'). Please ensure that the stabilizer locates the disc in
a centred and leveled position.
Close the disc drawer. The display shows
CLOSE
and
Reading Disc...
in
the next step. After reading the table of contents, the number of tracks and the
total playing time of the disc is displayed in minutes and seconds:
Total Time
Track
min
sec
16 74
:
03
Minutes of total
playing time
Number of
Tracks
Seconds of total
playing time
