30
7.3
Settings for Audionet preamplifiers
The Audionet Metal Remote Control has 6 additional keys to control an Audio-
net preamplifier (see previous section 'Key assignment Metal Remote Control').
Depending on their type, Audionet preamplifiers use different system addresses
as remote control code. A DIP switch on the circuit board of the Audionet Metal
Remote Control is used to select the desired system address.
The remote control has to be opened in order to set the system address (refer
to previous section 'Changing the batteries'). The DIP switch for selecting the
system address is located here:
Set the DIP switch labelled 'SYS ADDRESS' to position '19' or '16' according to
the following table:
Audionet preamplifier
Adress
STERN, PRE G2, PRE 1 G3,
WATT, SAM G2
DNA, DNP, DNA 1
19
MAP 1
16
Note
•
If not ordered explicitly otherwise, the Audionet Metal Remote Controls DIP
switch is always preconfigured to setting '19'.
•
Older models of Audionet preamplifiers use the system address '16'.
Tip
•
If you own an Audionet preamplifier that is not listed in the table above and
you don't know which system address it uses, simply try both settings.