11
5 Inputs and outputs
Important
·
During connecting and removing of sources or amplifiers to the
SAM 20 SE all units of your audio system have to be switched off
to prevent damage of the SAM 20 SE or any of the other connected
units.
·
Please make sure that all cables are in absolute best conditions!
Broken shields or short-cut cables could damage the SAM 20 SE
and/or any other connected unit.
5.1 Inputs
The SAM 20 SE is equipped with four RCA inputs 2 to 5 and one bal-
anced (XLR) input 1 for connecting signal sources at line level. RCA
input 6 is dedicated to connect a turn table.
Please connect the left and right input of the same number printed on the
back panel of the SAM 20 SE to the corresponding output of the source
you would like to connect to the SAM 20 SE.
5.2 Speaker terminals
Connect your speakers to the terminals 7 and 8 on the back panel of the
SAM 20 SE. You can use banana plugs or spades as well as simple cable
ends. Look out for the correct connection of your speaker cables. Usually,
the terminals of your speakers are marked '+' and '-'. The SAM 20 SE uses
the same marks.
Note
·
Wrong speaker polarization will result in severe loss of sound quality.
·
In case you would like to bi-wire your speakers please insert the cable
to the tweeters from the rear using banana plugs and mount the cables
to the bass speakers from the side. In doubt please ask your dealer for
assistance.
Summary of Contents for SAM 20 SE
Page 1: ...1 audionet SAM 20 SE Stereo Amplifier User s Manual...
Page 2: ...2...
