13
5.5 Phono
The SAM 20 SE is equipped with a phono preamplifier board. Use the in-
put no. 6
IN 6
6 marked as
PHONO
to connect your turntable to the
SAM 20 SE. Connect the earth wire of your turntable to the earth con-
nector
GND
13 . For further information on the phono preamplifier board
please refer to section '
Phono
' on page 34.
Important
·
Input no. 6
IN 6
6 must only be used to connect a turntable.
·
Input no. 6
IN 6
6 is not available for By-Pass mode (see section '
By-
Pass Mode
' on page 24).
5.6 Headphones socket
A 6.3 mm headphones socket 14 is located at the rear of your SAM 20 SE.
The signal at this socket can be switched on and off to allow the head-
phones to be plugged in permanently. Switching is easily done on the front
panel. Please refer to section '
Headphones
' on page 21.
5.7 Audionet Link
For your convenience, the SAM 20 SE can switch on/off all other Audionet
units (e.g. power amplifiers) connected via Audionet Link by a simple
touch on the remote control or the
power
key on the front panel.
You only need a simple optical 'Toslink' cable. Connect the Audionet Link
output
Link OUT
12 of your SAM 20 SE to the Audionet Link input of
the unit to be controlled.
Summary of Contents for SAM 20 SE
Page 1: ...1 audionet SAM 20 SE Stereo Amplifier User s Manual...
Page 2: ...2...