14
6 Usage
All functions of the SAM 20 SE are microprocessor controlled. This guar-
antees highest precision, exclusive functions, easy handling and protection
against operating errors.
6.1 Powering up
First of all, please make sure your SAM 20 SE is connected correctly to
mains power and to your signal sources (see section '
Installation and power
supply
' on page 8 and '
Inputs and outputs
' on page 11).
The SAM 20 SE is a stand-by unit. Please operate the mains switch 10 on
the back panel. The display shows a welcome message for a brief moment.
After that the SAM 20 SE is in stand-by mode.
Only in cases of extended absence (like vacations) or if massive trouble on
the mains power is to be expected (e.g. thunder storms) it is recommended
to disconnect the SAM 20 SE from mains power. While the SAM 20 SE is
in stand-by mode, operate mains switch 10 on the back panel. To discon-
nect the SAM 20 SE from mains power completely, you have to pull the
mains power cord off the mains jack 9 .
Important
·
Before you switch off the SAM 20 SE from mains, power down and
discharge completely all units connected to the outputs of the
SAM 20 SE.
6.2 Switching on and off
To power up the SAM 20 SE from stand-by mode, press the
power
key on
the front panel. The SAM 20 SE displays the message
Waking up..
. Af-
ter a short moment the unit is in normal operating mode and ready to use.
If you would like to switch off the unit, please press the
power
key on the
front panel. The display shows the message
Going to sleep..
and unit
enters the stand-by mode.
Note
·
Of course, you may switch on/off the SAM 20 SE with the Audionet
Metal Remote Control. For detailed information please refer to section
'
Audionet Metal Remote Control
' on page 29.
Summary of Contents for SAM 20 SE
Page 1: ...1 audionet SAM 20 SE Stereo Amplifier User s Manual...
Page 2: ...2...
