17
As soon as you enter the setup menu by pushing the
set
key, the display
changes to show information related to the selected menu item. For further
details refer to the description of each menu item in section '
Setup menu
'
starting from page 19.
Note
·
After 10 minutes without any user interaction the 'display saver' is in-
voked automatically. The display then shows only the number of the
currently selected input channel and the current volume level.
6.7 Input selection
Push the key
set
on the front panel for less than two seconds to enter the
system menu. The first menu item is
Select Input
. Press key
set
again. Now select the desired input channel with the keys
up
and
down
.
The last line of the display provides the number and the (user-definable)
name of the currently selected input channel. Push
set
again to actually
switch to the desired input channel.
Note
·
Leave the input selection function by holding down the
set
key longer
than 2 seconds.
·
Using the Audionet Metal Remote Control, select an input channel by
using the keys
CH+
and
CH-
to switch to the next or previous input
channel without using the
Select Input
function.
·
If you dedicated one of the input channels 1 to 5 to the By-Pass func-
tion (see section '
By-Pass Mode
' on page 24), this input channel is
marked by '*' after the channel number in the display during input se-
lection to remind you that switching to this input channel will activate
the By-Pass Mode.
Summary of Contents for SAM 20 SE
Page 1: ...1 audionet SAM 20 SE Stereo Amplifier User s Manual...
Page 2: ...2...
